Hi
I'm trying to achieve a similar outcome using a reprap to both 3D print and CNC mill. I found your post over on the HSMworks forum about using HSMExpress to generate tools paths which can be used by a RepRap CNC.
I downloaded the reprap.csm file and ran through the post process, process but ran into some problems. I'm made a post over at the HSMworks forum on your original topic but was wondering how you faired.
The machine I'm using is a combination 3D printer / CNC mill and is controlled by RAMPS 1.4 hardware with Marlin v1 3D printer firmware installed. The Pronterface 3D printer controller software is used to talk with the printer and send g-code to it for completion by the RAMPS board.
Any help you could offer would be most appreciated.
I'm trying to achieve a similar outcome using a reprap to both 3D print and CNC mill. I found your post over on the HSMworks forum about using HSMExpress to generate tools paths which can be used by a RepRap CNC.
I downloaded the reprap.csm file and ran through the post process, process but ran into some problems. I'm made a post over at the HSMworks forum on your original topic but was wondering how you faired.
The machine I'm using is a combination 3D printer / CNC mill and is controlled by RAMPS 1.4 hardware with Marlin v1 3D printer firmware installed. The Pronterface 3D printer controller software is used to talk with the printer and send g-code to it for completion by the RAMPS board.
Any help you could offer would be most appreciated.
